Full Version: Photo help - Corian
From: Cody (BOBTNAILER) [#1]
9 Apr 2007
To: ALL
I'm getting ready to put some photos on Corian shapes.
My question is: What settings would you use for this? I don't have extra pieces, and I don't want to make SCRAP.
I'm using a 35W Epilog 24TT, with PhotoGrav.
Thanks!
From: Stunt Engraver (DGL) [#2]
9 Apr 2007
To: Cody (BOBTNAILER) [#1] 9 Apr 2007
Unless all sides of the piece will be imaged, you should be able to run a test in an area that won't be seen on the finished product.
From: Cody (BOBTNAILER) [#3]
9 Apr 2007
To: Stunt Engraver (DGL) [#2] 9 Apr 2007
I did a test run on a piece that I had laying around. I used the settings that Epilog recommends for my machine, and the pic turned out fine.
The only issue will be with contrast. I tried your patented painting tool, but there just wasn't enough depth to the contrast.
I don't know that I want to spend the time required to find the right PhotoPaint settings to make the end result look good....probably not enough market here for that.
Thanks anyway, sir!
From: Stunt Engraver (DGL) [#4]
9 Apr 2007
To: Cody (BOBTNAILER) [#3] 9 Apr 2007
If there's not enough depth to "flood-fill" the image, Rub 'N Buff comes in a variety of colors and should work very well.