Full Version: Looking For Metal Blanks

From: Don (HIGHDESERT) [#5]
 17 Apr 2007
To: RALLYGUY (RALLYGUY1) [#2] 17 Apr 2007

Thanks Brian,

What I'm looking for is Pre-Made, Ready To Go Blanks in small quantities. However, if I ever get to the point where I need larger quantites I'll keep you in mind.


From: Harvey only (HARVEY-ONLY) [#6]
 17 Apr 2007
To: Don (HIGHDESERT) [#5] 17 Apr 2007

There was talk a while back about having metal parts cut by water jet machines. I do not remember anything about what the minimums might be.

From: RALLYGUY (RALLYGUY1) [#7]
 17 Apr 2007
To: Harvey only (HARVEY-ONLY) [#6] 17 Apr 2007

Minimums are normaly down to 1 piece, but the programming charges get ya ;)

Waterjet cuts typicaly leave a bad burr on thin stock aluminum....Harder metals aren't too bad though.


From: RALLYGUY (RALLYGUY1) [#8]
 17 Apr 2007
To: Don (HIGHDESERT) [#5] 17 Apr 2007

Thanks for the reply....


Sorry it wasn't a good match this time.


From: Harvey only (HARVEY-ONLY) [#9]
 17 Apr 2007
To: RALLYGUY (RALLYGUY1) [#7] 17 Apr 2007

Thanks for that information, never heard that aluminum would give a problem but good to know.

From: Stunt Engraver (DGL) [#10]
 17 Apr 2007
To: Don (HIGHDESERT) [#1] 17 Apr 2007

Don,

Identification Plates has a wide variety of dies for fabricated metal plates.

http://www.idplates.com/cf1.html

Low set up charges and minimums.

From: RALLYGUY (RALLYGUY1) [#11]
 17 Apr 2007
To: Stunt Engraver (DGL) [#10] 17 Apr 2007

Frank from Chewbarka may also have some pre-cut blanks and or dies in various shapes....

From: Stunt Engraver (DGL) [#12]
 17 Apr 2007
To: RALLYGUY (RALLYGUY1) [#11] 17 Apr 2007

Brian,

That's true. The company has a long history in die cut metal, but it may be limited to smaller pieces.

Show messages: All  1-4  5-12

Back to thread list | Login

© 2024 Project Beehive Forum