Full Version: Strange Line

From: Brian (BRIAN_R) [#5]
 19 Apr 2007
To: ALL

Thanks, I think I've got it. "If all else fails, read the instructions" is my motto!

From: gingem [#6]
 20 Apr 2007
To: Brian (BRIAN_R) [#3] 20 Apr 2007

Your outline has 3 pieces and you really need to smooth the outline by removing some of the node. There is something in the center of the outline and a leg piece that is also inside the outline.

From: Brian (BRIAN_R) [#7]
 20 Apr 2007
To: gingem [#6] 21 Apr 2007

Thanks Bill,
I know how to fix the nodes and I'll get on that.
I just don't know why it's in 3 parts and why it didn't raster. I saw the 3 sections in the object manager when I was trying to engrave. I thought maybe one was shut off but I couldn't find it.
Like I said, it vector cuts fine.
It straight from trace and I haven't fooled with it yet. If it's filled it rasters fine, it's just when I increase the line width that it won't engrave the whole thing.

From: Harvey only (HARVEY-ONLY) [#8]
 20 Apr 2007
To: Brian (BRIAN_R) [#7] 20 Apr 2007

I have not looked at the file since you are going to work on it, but have an idea.

When you thickened the line, you might have missed a piece. It may show the same on the screen but may really be thinner.

From: Brian (BRIAN_R) [#9]
 20 Apr 2007
To: ALL

OK,
New and improved (maybe) ;)

From: Dave Jones (DAVERJ) [#10]
 20 Apr 2007
To: Brian (BRIAN_R) [#9] 20 Apr 2007

I don't know if this will fix it or not. Give this one a try. I took your improved version and made an inner contour. Then filled the original with black and the contour with white. The result should look about the same, but everything should be thick enough to raster engrave.

From: Brian (BRIAN_R) [#11]
 23 Apr 2007
To: Dave Jones (DAVERJ) [#10] 24 Apr 2007

Dave, thanks for the help. I'd already tried again before I saw that you had replied.
Looks like after I got rid of the thousands of nodes it worked just fine. I still don't know why. What appeared to be 3 lines turned into 2 (that's what it should have been) and lasered just fine.
I need to remember to go back after tracing and clean up the nodes.

Show messages: All  1-4  5-11

Back to thread list | Login

© 2024 Project Beehive Forum