Full Version: NH Cartridge Controller 23-002-40 for Vanguard 4000

From: Reed-o (WINFRED) [#1]
 30 Dec 2020
To: ALL

Hello all. I'm new here. I ask you to be patient with me. I am in great need for a copy of the operators manual for a New Hermes Vanguard 4000 engraving machine. I especially need the pages that shows the area where job set-up, dwell, cutting, job size, margins and all input data. With out this I'm lost. Working in the dark.
I'm happy to pay for an original book or a copy either pdf or hard. This is the old flat controller that uses cartridges. Can you please help.
I can't cross it over to a PC as much as I like to. Don't have the skill nor the money.
Thank you kindly and good day.
I hope I can find someone to help.

Sincerly,
Winfred Reed

Reply


Reply to All

Back to thread list | Login

© 2021 Project Beehive Forum