Pretty Nifty! What size is the box? Can it hold a 6-pack along with ice?

Did you caulk it or did the glue handle it?

Michel

It was cut from flat panels , then we used marine silicon caulking (clear) to "glue" it together and furthermore strengthened it with corner brackets at the bottom and the ones you see at the top

To get the logos to glow , one needs a flat edge that sits on top of the LEDS , hence making it that way. The opal diffusor is dropped into the tub after , the tub itself rests atop the LEDS with locators to keep it in the position it needs to be in for the edge lit effect.
Will take 12 bottles of the product + a full ice load.
Box is 500mm x 250 mm x 200 deep (20" x 10 x 8")

Rodney,
You just amaze me. I can't believe all of the beautiful stuff that you make with your laser. I hope someday, I can do half as good.
I am sending a photo of a lamp that I made from your pattern. I jazzed it up a little with some stones that I had for jewelry making. I hope you like it, and thank you for all of your tips and tricks. They are wonderful.

Barbara

Barbara - Those are beautiful!

We just finished our Fall Festival show. We had two of these lamps on our table for sale...neither one sold. HOWEVER, there were SEVERAL folks that almost passed by our booth without stopping, and when they saw the lamps (turned on), they came back and looked at our table.

Thank you Cody,
I haven't sold it either. I have only made two.. The first one had a photo
on the top and I made it purple and clear, and then with the cutouts from the inside, I glued one purple and one clear onto the front, and it looked pretty cool.
Thanks for the compliment on them, now all we have to do is start selling them.
Barbara