Acrylic Plaque - Engraving Etc. Forum

From:	Harvey only (HARVEY-ONLY)	14 Oct 2006
To:	Griffo (LASERWEST)	3 of 7

5080.3 In reply to 5080.2

At times a JPG and Internet Explorer 6 do not get along. There have been a few in the past and John has looked at them and found nothing wrong, but....

When I try to open them nothing happens, then when I click on a thread link nothing happens but the thread gets marked as read but never pops up. It only seems to happen in IE. Closing IE then re-opening it fixes the problem until you click on that picture again.

You CAN view it safely by right clicking on it and selecting 'View in new window'.

I think it happened after a Window's update.

Philadelphia, PA (Really Bensalem)

When you finally understand it completely... it changes.

From:	Stunt Engraver (DGL)	14 Oct 2006
To:	Griffo (LASERWEST)	4 of 7

5080.4 In reply to 5080.2
Dave, I embedded Jame's photos into his original post. Try it now. David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

From:	Griffo (LASERWEST)	14 Oct 2006
To:	Stunt Engraver (DGL)	5 of 7

5080.5 In reply to 5080.4

Harvey.
Thanks for the tip I'll keep that in mind as I've had trouble elsewhere.
I've just updated

David:
Thanks for making it easy.

James: Nice work and NICE TIP.

Thanks again guys. This really is a great site, it has helped me tremendously

Regards
Dave

From:	Mike (MIKEN)	14 Oct 2006
To:	James (TILER02)	6 of 7

5080.6 In reply to 5080.5
James Very nice work. Would you mind sharing your secrets for doing such a nice color fill. Mike Dist. of Lazer Cutting Grid www.stl-laser.com

From:	James (TILER02)	16 Oct 2006
To:	Mike (MIKEN)	7 of 7

5080.7 In reply to 5080.6
Mike, There is not really any trick to the color fill. Make sure the engraving is pretty deep then using a piece of cardboard I spread the paint on, let it dry then remove mask. If I need it to dry quick I put it back in the laser with the exaust running. This dries it quick.