Air Assist Levels - Engraving Etc. Forum

From:	Goodvol (JIMGOOD)	24 Feb 2007
To:	Cody (BOBTNAILER)	7 of 9

6134.7 In reply to 6134.6

All this talk about food and a breast! 8-O

You're making me hungry!!!

Jim

From:	(Brian) (MOSTLY_HERE)	25 Feb 2007
To:	Goodvol (JIMGOOD)	8 of 9

6134.8 In reply to 6134.1
The air pump should pump out around 30 psi. There should be a needle valve in your machine to drop the pressure down a bit. That would be helpful if you were cutting something very thin like paper or cloth. Brian(Mostly_Here) Las Vegas (Sin City) Good decisions come from experience, and experience comes from, well bad decisions...

From:	Goodvol (JIMGOOD)	25 Feb 2007
To:	(Brian) (MOSTLY_HERE)	9 of 9

6134.9 In reply to 6134.8

Brian,

I need to check to see if I have an adjustment. The instruction booklet does not discuss any adjustment but the assembly drawing shows an "adjusting screw" so I'm hoping that is for the flow.

I'm showing around 9 psi when I'm vector cutting. The model says the max air pressure is 30 psi so I'm assuming I can adjust it, if needed. I seem to be getting a little more burn than I think I should. I need to also check the location of the flow. Maybe it isn't hitting the right spot. I'll check it out.

Thanks for the help!

Jim

Show messages: All 1-6 7-9

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!