bronze resin - Engraving Etc. Forum

Press Ctrl+Enter to quickly submit your post

Quick Reply

✏✏✏✏✏✏✏✏✏✏

From:	Stunt Engraver (DGL)	15 Mar 2007
To:	MR C (MOSHE)	17 of 19

6328.17 In reply to 6328.16
$45-$50 sounds more worthwhile, than $25-$35. Cost is less than bronze, which should be appealing to the customer and in the quantities you mentioned, enough money to make it worth your while. It's a good combination. :-) Good luck! David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

From:	Engravin' Dave (DATAKES)	15 Mar 2007
To:	MR C (MOSHE)	18 of 19

6328.18 In reply to 6328.14
May I ask who your supplier is at these rates? Is it a Canadian supplier?

From:	Engravin' Dave (DATAKES)	15 Mar 2007
To:	MR C (MOSHE)	19 of 19

6328.19 In reply to 6328.7

I can't remember how long it took to engrave the small piece in the photo. I know I had to run it three times with my 30-watt laser to get a reasonable depth. I actually should have run it one more time.

A higher-powered laser is the tool for this substrate. Routing may also be okay if fine detail is not required.

Show messages: All 1-16 17-19

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!

Forum Stats