Folder Laser EngravingHow can I tell laser vs rotary

Warning Press Ctrl+Enter to quickly submit your post
Quick Reply  
✏✏✏✏✏✏✏✏✏✏
 
 
  

Previous
Next
 From:  Harvey only (HARVEY-ONLY) 29 Mar 2007 
 To:  Becky (KIAIJANE)  6 of 7 
6465.6 In reply to 6465.4 
They have just stopped making laser royal blue brass. I have a large client that used it, had to switch to laser steel.

Philadelphia, PA (Really Bensalem)

When you finally understand it completely... it changes.
 

Previous
 From:  Becky (KIAIJANE) 29 Mar 2007 
 To:  Harvey only (HARVEY-ONLY)  7 of 7 
6465.7 In reply to 6465.6 
The plaques are for Sertoma. They are purchased through the Sertoma website. They are mass produced and engraved either through the Sertoma website or by the purchaser. I did send an email to see if I could get any info from them.

Probably in this case, better safe than sorry.
Thanks all
Becky
 
 
     
 

Show messages: All  1-5  6-7

Rate my interest:

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 |  FAQ |  Docs |  Support |  Donate! ©2002 - 2025 Project Beehive Forum

Forum Stats