Corel vs Illustrator - Engraving Etc. Forum

From:	Pedaler (ROYBREWER)	14 Apr 2007
To:	Mike (MIKEN)	28 of 31

6621.28 In reply to 6621.25
Mike, Sounds like a terrific project. I hope you'll be able show the finished model. When are the "real" gates scheduled to be completed? Roy Brewer http://www.engravingconcepts.com Epilog/Xenetech distributor

From:	Mike (MIKEN)	14 Apr 2007
To:	Pedaler (ROYBREWER)	29 of 31

6621.29 In reply to 6621.28
Roy: I have sent a request for a picture to the artist. The installation should be completed in June. The model was made at the request of the donor of the steel for the gates. I will follow up on this even if I have to take pictures of the real thing once installed. Mike Null Dist. of Lazer Cutting Grid www.stl-laser.com

From:	William Desrochers (DRAKESIS)	15 Apr 2007
To:	LaZerDude (C_BURKE)	30 of 31

6621.30 In reply to 6621.1

Illustrator CS can open CDR 10 and under files, as CMYK or RGB.

I use both Illustrator CS and Coreldraw 12, and honestly there's not a lot of difference between both. There both just as good for vectoring.

William Desrochers
Excalibur Creations & Recognition
"Cutting Edge of Quality & Design"
http://www.excaliburcreations.com

Raster Bitmap to Vector Conversion Service
I specialize in converting raster bitmap images into high quality vector artwork. All work is done by hand, accurately and quickly by me.

From:	LaZerDude (C_BURKE)	15 Apr 2007
To:	William Desrochers (DRAKESIS)	31 of 31

6621.31 In reply to 6621.30

Thank you William,

I appreciate your input. The conclusion I have come to is to Keep on using X3 and upgrade Photoshop.

I will try some of the tricks mentioned here regarding pre processing as well.....

Thanks again for your help.

Show messages: 1-7 8-27 28-31

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!