The trick to beveling small widths, i.e. 3/8" is not to bevel such small widths. Sounds logical enough, but that doesn't make sense -- or does it?
Here's what you do:
Let's say you need a number of 3/8" x 2" plastic plates. Cut a 2" x 12" length from a piece of sheet stock.
Bevel the two 12" long sides.
Guess what? By beveling the 12" widths, before you cut the individual plates, you've already beveled the small widths.
That means, after cutting the individual plates, all that's left to do, is bevel the 2" widths.
David "The Stunt Engraver" Lavaneri
DGL Engraving
Port Hueneme, CA |
