Color
Filling FRP Plastic
|
To color fill engraved FRP is simplier than most
other materials: |
- Engrave at about .004 depth with a flex bit, if a
little color still shows, (not often), re-engrave
at .006.
- Get a sharpie or good marker and fill in the
letters.
- If done fast almost all of the fill will
just wipe off the surface. If not faintly
moisten a paper towel with alcohol, I use
denatured alcohol just because it is easy
and cheap. Alcohol will usually clean
every bit of sharpie off an item, but on
the UnisubFR it just wipes off the
surface, what is inside the engraving
remains untouched for some reason. Black
is great, red is not bad. I have not
checked out the other colors
That's all folks.
|
Philadelphia, PA (Really Bensalem)
Harvey's Sub Page When you finally understand it completely... it changes. |