Hello everyone..
My name is harnihal (i know bit difficult to pronounce) i am new to this forums....i am a gun enthusiast too and always loved the guns with engravings the most ,i have a questions for experts how much can customised hand engraving on sword which is probably 30 inches long 2 inches wide can cost including hilt which had gold inlays can cost from a hand engraver

Thank you i look forward for replies
Harnihal sidhu

Welcome to the board. I am sure some people here have done swords, I tend to remember a few discussions.

I am sure someone will jump in with some answers.

As far as hard to pronounce, try my last name, Lentchner.

Philadelphia, PA (Really Bensalem)

Harvey's Sub Page When you finally understand it completely... it changes.

Hi and welcome,
My name is Ron Huntington and I do a lot of hand engraving, but not on what you are talking about. There are quite a few variables that need
to be found out before a cost is established. I would look at a web site
of someone like Sam Alfano. Do a google seach for hand engravers and
I am sure that you will find many examples of what you need.