Jim Williams, CRM - Engraving Etc. Forum

From:	Stunt Engraver (DGL)	21 Mar 2006
To:	ALL	1 of 3

3259.1
Jim Williams, is host/moderator of the Trophy and Awards Engravers forum ( on Yahoo). During the past ARA Las Vegas show, Jim received his Certified Recognition Master (CRM) classification from ARA. Keep your eyes out for an upcoming article, written by Jim, in "Recognition Review" (ARA trade mag). Writing an article for the magazine is a prerequisite to a person achieving ARA's CRM status. Congratulations Jim! David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

From:	John (ICTJOHN)	22 Mar 2006
To:	Stunt Engraver (DGL)	2 of 3

3259.2 In reply to 3259.1

David,

ARA dropped the "published" requirement awhile back.

Now you must write a paper AND if they feel it is good enough, they will refer it over to the magazine editor............ I just talked to Daniel Weinstock about this very subject in Las Vegas as I am getting close to finalizing the CRM as well. I am not a journalist or even a hack writer, so I was concerned about the PAPER. Turns out I can select any relevant subject and fire away.

John
http://www.creative-awards.com
creativeawards@msn.com

From:	Stunt Engraver (DGL)	22 Mar 2006
To:	John (ICTJOHN)	3 of 3

3259.3 In reply to 3259.2
John, Thanks for updating my knowledge of the CRM requirements. I really don't know much about the certification program. This tidbit was something I read on Jim's forum. David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!