Acrylic strip heater - Engraving Etc. Forum

Press Ctrl+Enter to quickly submit your post

Quick Reply

✏✏✏✏✏✏✏✏✏✏

From:	Stunt Engraver (DGL)	24 Apr 2006
To:	James (TILER02)	5 of 6

3610.5 In reply to 3610.1

James,

Does your strip heater have a thermostat?

Depending on the thickness of the acrylic, you'll probably need about 300 degrees.

You shouldn't need to place anything over the acrylic, to hold in contact with the heating element.

David "The Stunt Engraver" Lavaneri
DGL Engraving
Port Hueneme, CA

EDITED: 24 Apr 2006 by DGL

From:	Harvey only (HARVEY-ONLY)	24 Apr 2006
To:	Stunt Engraver (DGL)	6 of 6

3610.6 In reply to 3610.5
I use a premade strip heater, in a case. I place a piece of wood over the plastic to keep it from warping if it is thin, (wood is a fairly good insulator and if it does not start to turn brown you have not exceeded its temperature limit). Thicker I use nothing. It works very differently than an unrollable heater so no advice for that. Philadelphia, PA (Really Bensalem) Harvey's Tips Page When you finally understand it completely... it changes.

Show messages: All 1-4 5-6

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!

Forum Stats