I have just got into engraving 3mm rigid laminate ( yellow/black/yellow sandwich stuff). I have now just received my first order for 80 engraved panels, the panels are 145mm x 215mm, I have no problem with the engraving, my engraver only holds one tool and i would need to change the cutter to achieve a sharp profile, this could make the job very long winded. I need to cut the profile out quicker with out chipping the top or bottom layer, any recommendations on what type of cutting equipment I should use and if circular saw, what width/no of teeth on the blade I should be looking at.
One other question is it possible to colour file on darvic after engraving using a screen printing process?

Wayne - give me a little more information on the laminate your using - do you have a company name of it, website with more info about the laminate or even the supplier you get it from. With that info I might be able to give you a little more input. We do a lot of signage and depending on the product different ways of cutting produce very different results.

Thanks

If it is square cuts, not shapes, you probably can use a table saw.

Not knowing the material I can only suggest a generic blade that works well on acrylic and most plastics well.

The generic specs are a non-Ferris cutting blade, C4 carbide teeth, at least 80 on a 10" blade. It should be a triple chip design, but there are now two triple chip designs, you need the one with the center chip tooth the same length as the other two. They are now making blades with a protruding center chip tooth. It works better on metals, but will cause a small chip on the bottom surface when you exit acrylic. The C4 carbide will last for years doing a lot of acrylic before needing resharpening.

Philadelphia, PA (Really Bensalem)

Harvey's Tips Page When you finally understand it completely... it changes.

I believe the Rigid Laminate Also known as Traffolyte or Formica
see web page for pic and details

http://www.suregrave.com/rigid-laminate.html

Material: Multi-layered Hight Pressure Laminate
Finish: Gloss
Sheet size: 1220 x 1220mm, 1220 x 610mm
Thickness: (3 ply) 1/16", 1/8", some 5 ply
Uses: Interor Signs
Cutter type: Rotating carbide
Cutter depth: No less than .012"
Fabrication: Saws, Drills and Bevels
Other features: Suitable for double-sided engraving

regards
wayne

You may consider using a template and a 3 flute following (more flutes, better finish) bit with a router......

If you have the ability, you can clamp several pieces together and do them all at one time if your following bit is deep enough.

Cut the piece close to size, clamp or fasten to the jig then route to final size.

Create the template then use the following bit to create copies.

Hope this helps....