Golf Trophy - Engraving Etc. Forum

From:	Precision Laser Creations (PIZZAMAN)	27 Jun 2006
To:	ALL	1 of 4

4188.1
I have a customer who needs a big golf trophy(about 3 feet tall) that can have plates added each year it is given. I gave him catalogue pictures of big walnut bases with a 1 foot golfer on top. He would prefer a trophy with tall columns. Any ideas on how I can incorporate a trophy with columns on a base that will accept multiple plates? Thanks, Tony
EDITED: 27 Jun 2006 by DGL

From:	Stunt Engraver (DGL)	27 Jun 2006
To:	Precision Laser Creations (PIZZAMAN)	2 of 4

4188.2 In reply to 4188.1
Tony, One way to accomplish that concept, is to build a 4-column trophy, leaving ample room for a plaque board in the center area. Attach a rod to the bottom of the plaque board, so it can be attached to the base, much like a trophy figure. Plenty of room for individual plates. David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

From:	Harvey only (HARVEY-ONLY)	27 Jun 2006
To:	Precision Laser Creations (PIZZAMAN)	3 of 4

4188.3 In reply to 4188.1
I have seen trophies like that with a tall board as the center column. The plates were added to that. Philadelphia, PA (Really Bensalem) When you finally understand it completely... it changes.

From:	Ozzy Fox (CLIVEGARAWAY)	13 Jul 2006
To:	ALL	4 of 4

4188.4

I have a couple of golf customers who have a long plaque say 3 ft x 8in, with a golf club mounted on it and the plates 2 up running down beside the handle, One customer had the 'stick' bent into a corkscrew for the hack event, (whenever it was in for update I used to leave it in the window for novelty effect) sorry I don't have any pics. One had a flat piece of wood for the base, one was wall mounted. Just another idea.

Clive

Ozzy Fox
Clive ~ Fox trophies (Down under)

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!