I read the info on engraving trays, educational.
The only suggestion I would have is instead of engraving on air, use 3 layers of Scotch tape or a single layer of the clear vinyl transfer tape. Unscrew the drag pit and use a faint bit of finger pressure on the bit.
This will give clear lines exactly where the bit touches and not leave any mark on the product.
My wife came up with the transfer tape. It is tougher than the Scotch tape and also leaves a good line. It can also be bought in many widths, a major bonus.
Philadelphia, PA (Really Bensalem)
When you finally understand it completely... it changes. |