Thank you all for your help. Found the problem and it is engraving beautifully again. The problem was when I moved it to get the serial number off the back the parallel type cable came loose and when I pushed it back on one of the pins bent. As soon as we straightened the pin and plugged it back in everything was fine. One of the first things I had done was check the connections but apparently wasn't paying real close attention.

Sure glad I didn't take the listing off eBay last night. I just extended it for 3 more days to give me time to check things out. I did discover that the spindle light is burnt out but spindle still rotates.

Bruce your message is what made me go back and look at the connections again.

Thanks again for all your help.

Don't know what I would do without you all!

Mary
Ozark Engraving
Bull Shoals, AR 72619