I am trying to get my vision 1212 engraver to work, and can't just seem to get it to start engraving using engravelab 7.
Now, I haven't used Engravelab nor this engraver before, so I'm sure I'm doing something wrong - any advice is appreciated.
Connections appear to be good. I'm on the correct Com port 2(I tested it on a label printer I have, and it printed fine, so the port/cable works). I have the port configured at 19,200, N, 8, 1, hardware.
When I send a job to the engraver, a little dialog box pops up, shows numbers and reads:
Engraving to Com2:
Bytes Sent: 444
Then it just gets stuck there. The green start button doesn't light on the engraver doesn't light.
Question on the engraver:
Should it move or something when I turn it on? It just sits there, flashes lights, and then the lights go solid. I can turn the prox sensor on/off, the pause button will turn red. The jog up/down doesn't do anything, the green button for turning spindle on/off stays on.
Can someone give me some trouble shooting tips?
Thanks. |