EngraveLab - Engraving Etc. Forum

From:	Jo (OAAE)	9 Sep 2006
To:	ALL	1 of 5

4813.1
Hi folks, Todd here, Jo's hubby. I just purchased Engravelab for our Laser (Universal Versalaser VL200). Does anybody use this software? I think I need to install all new drivers due to the fact I have been using Corel's X3. Thank You in Advance Folks. Todd
EDITED: 10 Sep 2006 by DGL

From:	laserman (MIKEMAC)	11 Sep 2006
To:	Jo (OAAE)	2 of 5

4813.2 In reply to 4813.1

Todd,

I think the only way that you can use the Versa and engrave lab is with the ADVANCED driver. I am not really sure if the materials based driver will work.

I might be wrong but it is not hard to figure it out just try and print from engrave lab using the materials based driver.

CEM- Sales and Service of Universal Lasers, Versa Lasers, and Meistergram / H-square engravers.
2800 S. Main St.,Unit C
Santa Ana, Ca 92707
714-444-2385

From:	Bill (ALBILLBERT2000)	12 Sep 2006
To:	Jo (OAAE)	3 of 5

4813.3 In reply to 4813.1
Hi.. not sure about your machine. but I have a 30 watt universal using engrave lab.. and I would never use corel knowing what engrave lab can do.. it drives all of our machines.. from vinyl cutters to Wizzard engravers.. I really like it.. check with universal.. I think its just a printer driver you need..

From:	Myyk	12 Sep 2006
To:	Bill (ALBILLBERT2000)	4 of 5

4813.4 In reply to 4813.3
I have EngraveLab v6 and I would never use it on my laser. It seems full of bugs and is sometimes quite unpredictible. It's Corel every tme for me. I have to use it on my rotary machine and most days I swear at it. (And I have been using EngraveLab for years) I used to like version 4.95 until I became more proficient with Coreldraw. I guess it really comes down to your own preference and how you carry out your work. I have obviously failed to come to grips with the changes from Version 4.95 to Version 6.

From:	Bill (ALBILLBERT2000)	13 Sep 2006
To:	Myyk	5 of 5

4813.5 In reply to 4813.4

I don't know how to answer your reply other than your right with comfort level.. I use both corel and Engrave lab and I think Engrave lab is great... so there.. lol...

Every thing depends on learning and feeling good with what you use.. and not having bugs.. or glitches..

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!