"I have read, it has NOTHING to do with the laser"
It has EVERY thing to do with the laser. Send me you address and I will send you some AlumaMark you can see for your self. YOUR Versa will do it also! If you had read ever thing I have said about the Versa you will note I said you don't see it on MOST materials.
"I certainly don't have the experience that you may have, but nevertheless, I think it is somewhat presumptous and a bit misleading to newbies lurking out there to claim that "ALL" lasers have the "issue" that you are describing."
As you can see from Roy's post ALL Lasers have this "issue"
it comes down to how well the manufacture has dealt with it,
and dose it show up in your application?
over all I think the Versa is a great little machine it would have been nicer if they had allowed for two more inches of over travel so I would not need to nudge AlumaMark over!
Also 12X16 table size REALLY screws up EngravPro. But thats a whole new can of worms and I do have Two Explores to deal with that end of production. My bad for not knowing that you start out with a 12 X 16 page. Got to do the homework! To big of a rush to go play cards. :+( |