Tricks & TipsBirth Certificate Holder
Thank you David.
Is there enough resistance in the rubber, to keep a part from "squirming" if a lot of pressure (drag) were introduced?
David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA
EDITED: 16 Nov 2006 by DGL
It is a fairly hard rubber. I can use full tension on my IS400 without much play. The ability of the item you are engraving to withstand a moderately strong vice clamp helps.
David Takes Expressions Engraved Acrylic Awards, Crystal Trophy, Glass Award, Plaques http://www.expressionsengraved.com
EDITED: 7 Aug 2010 by DATAKES
