Folder Corel Drawwelding text


Warning Press Ctrl+Enter to quickly submit your post
Quick Reply  
✏✏✏✏✏✏✏✏✏✏
 
 
  

Previous
Next
 From:  ab_laserart
 To:  Dave Jones (DAVERJ) 
5709.10 In reply to 5709.9 

DAVE, YOU'RE A GENIUS!!

I knew it could be done without first having to attain a graduate degree in rocket science! (Unless, of course, you have a graduate degree in rocket science) 8-O

Thank you very much,

Ron

 

Previous
Next
 From:  Pedaler (ROYBREWER)
 To:  ab_laserart 
5709.11 In reply to 5709.10 
Ron,

I know you said Corel 12, but the SmartFill tool with X3 makes this with fewer strokes.

Roy Brewer
http://www.engravingconcepts.com
Epilog/Xenetech distributor

 

Previous
Next
 From:  Harvey only (HARVEY-ONLY)
 To:  Dave Jones (DAVERJ) 
5709.12 In reply to 5709.9 

I tried to answer a few hours ago, but Verizon and Web service were not getting along very well at that time.

What an elegant solution. I printed it out for future use. It will get a lot of that with my projects. Thank you. Thank you. Thank you.

Philadelphia, PA (Really Bensalem)

When you finally understand it completely... it changes.

 

Previous
 From:  LaZerDude (C_BURKE)
 To:  ab_laserart 
5709.13 In reply to 5709.10 

Ron,
Dave did what I was wanting to do. There you go. I knew there had to be a pretty easy way and that was it.

 
 
     
 

Show messages: All  1-9  10-13

Rate my interest:

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 |  FAQ |  Docs |  Support |  Donate! ©2002 - 2024 Project Beehive Forum

Forum Stats