Meistergram Servo - Engraving Etc. Forum

Comp. Mechanical Engraving/CNC Meistergram Servo

Press Ctrl+Enter to quickly submit your post

Quick Reply

✏✏✏✏✏✏✏✏✏✏

From:	clay (CLAY_J1955)	14 Jan 2007
To:	ALL	1 of 6

5758.1

what would be the software of choice to run one of these machines??

thanks
Clay

EDITED: 14 Jan 2007 by DGL

From:	Stunt Engraver (DGL)	14 Jan 2007
To:	clay (CLAY_J1955)	2 of 6

5758.2 In reply to 5758.1

Clay,

I think they ran/run on native (proprietary) software.

David "The Stunt Engraver" Lavaneri
DGL Engraving
Port Hueneme, CA

EDITED: 14 Jan 2007 by DGL

From:	clay (CLAY_J1955)	14 Jan 2007
To:	Stunt Engraver (DGL)	3 of 6

5758.3 In reply to 5758.2
do you remember what its called, right now its running thru an .plt converter.

From:	Stunt Engraver (DGL)	14 Jan 2007
To:	clay (CLAY_J1955)	4 of 6

5758.4 In reply to 5758.3
Clay, This would be a good question for Mike Mackenzie. I'll page him. :-) David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

From:	Stunt Engraver (DGL)	14 Jan 2007
To:	laserman (MIKEMAC)	5 of 6

5758.5 In reply to 5758.4
Mike, You've worked extensively with H-Square/Meistergram equipment. Any words of wisdom for Clay? Thanks, David "The Stunt Engraver" Lavaneri DGL Engraving Port Hueneme, CA

From:	laserman (MIKEMAC)	15 Jan 2007
To:	clay (CLAY_J1955)	6 of 6

5758.6 In reply to 5758.5

Clay,

It would depend on the age of the system. Some of these systems used Engravelab and some used Engrave98 which is a windows version of d1.4. Some of the systems even use this old dos based software today.

CEM- Sales and Service of Universal Lasers, Versa Lasers, and Meistergram / H-square engravers.
2800 S. Main St.,Unit C
Santa Ana, Ca 92707
714-444-2385 Cem Lasers

Adjust text size: Smaller 10 Larger

Beehive Forum 1.0.1 | FAQ | Docs | Support | Donate!

Forum Stats