I have moved on to the software. I have engraved a few graphics on some test material.
I am having a hard time finding the starting point of the laser. One thing that is throwing me off is the direction of the table.
The top of the software is up like a normal page but the lasers top of the page is to the left. So everything is 90 degrees off CCW.
There is no scale on the table, I may have to put something in there to help me, at least in these early stages.
The clamping device is ackward. It is a spring loaded bar. The bar slides toward the top of the table, not the top of the page. There might be a way to change the top of the page in the software but I haven't found it yet. I will post pictures.
First picture is the clamp, second is a blurry picture of a tag.
Steve |