Hi
I have a little job to do using rigid laminates. I will need to rotary engrave, and then cut out some shapes.
I have never worked with the stuff before - my experience is with brass and flexible plastics. I've got a few bits of scrap to test out on - any tips before I start would be appreciated
Is there any general guidance anyone can give on engraving and profiling the material.
I am looking for info on the correct cutter geometry. For profiling will a standard parallel cutter suffice, or should I be looking at something more robust - some kind of router bit? I have a bottom loading collet for this.
Is there any gerneral guidance on speeds / feed rates for this material.
Thanks
Andrew |