Man I feel stupid. Going from laser to mechanical really makes me see how much I don't know!
On my EGX 30, there isn't any kind of rulers or guide rails...how do I know where something is on the page to start engraving? For example, if I put a 1x3 plate in the center of the engraving table, how do I know where that reference is in Dr Engrave? I know I can change the origin point, but it just doesn't seem like that's very accurate??? And it's not like lasering where I can just mask and see if it's right...
Mike
Space Engravers
www.space-engravers.com
25W Epilog Profile |