It takes 2 passes at 4:51 each to cut 24 plates.
Rowmark suggested leavng the protective plastic on, vector cutting, then removing the protective sheet before rastering. I cut 2 sheets with the protective sheet on, and the scorching peels off.
Still going to be a huge job if it goes through. We are going to negotiate price this week.
This is 1/8 inch LaserMax. I vectored at 25 speed, 90 power today and it cut pretty nice, but still not perfectly...I had just a millimeter or sot of material uncut. The tech girl from Rowmark wanted me to use 6 speed and 100 power. It cut well, but it took 19 minutes. I saved 5 minutes using my settings. I have a 35 watt Epilog.
I'm still trying to find the optimal settings. I'm going to make some test cuts on scrap material tomorrow.
Edsel Emery
Emery Laser Engraving |