Mick,
Thank You for your generous offer. I'll take you up on it. I know you are extremely busy and didn't want to pester you, but since you offered....
The good news is.. After trying a half a dozen different heat and time settings this morning, I finally got a very nice Transfer onto Aluminum. I set the heat at 300 for three minutes. I waited until the substrate was just slightly warm and then removed the transfer.... And Success!!!
I do have a few questions I'd like to ask here on the Forum. First, could you post or email me a general settings guide for different materials? I printed one that Harvey did and it has been a big help, but I need all the help I can get. Also, would it be a good idea to get a Convection Oven and put my finished transfered jobs into the oven for awhile? I want to transfer photos to metal plates (brass, aluminum, etc.) and then attach the metal plates onto signs that I have either laser engraved or Sandblasted. Do you know if the VersaTrans Transfers will hold up outdoors if I apply a spray UV protectant like Frog Juice or Krylon UV-Resistant Clear, or Clear-Jet? And Finally, where to purchase a tape dispenser for the heat tape?
Thanks again Mick
Don
High Desert Engraving & Sign Co. |