I have engraved the back of JDS's mirrored picture frames with good results. A customer called and wants names put on a large 28" round mirror. Because of doing the picture frames I figured it might be worth a shot. I will have to run with front door open.
Are all mirror backings created equal? That is, should I expect there might be a problem in lasering the backing off and painting?
If it doesnt work and I dont laser the glass itself can I spray the back to make it work as a mirror once again?
I told her I had the best resources available to man to determine whether or not I can do this job.
She wants up to 2" lettering..........not sure if that in itself would be a problem.
I did a search but didnt get a concrete answer......maybe because I was looking for a answer concerning mirrors... >.<
Brian |