It did not work, then it did. (Corel 9, have to try it with X3.)
When you go into the text mode, you get the text cross hair. If you touch the line you get an A with a curve under it. BUT go just inside the line and it changes to something inside a rectangle, BINGO that is the cursor that does it. (Just found out that by holding shift it changes to the inside thingy also.)
Thanks.
Is there a way to change the spacing to the edge or do I have to set up the curve to smaller than the area put in the text and then make the control curve outline clear?
This will be a mighty tool for some of the things I am currently doing. Thanks again.
Philadelphia, PA (Really Bensalem)
When you finally understand it completely... it changes. |