The way I tell which side is the slip is to scrap the surface with your fingernail; if it digs in, its the slip side, if it just slides over the surface, its the carrier side. This assumes 2 things, first that you have fingernails and secondly that the carrier side is the last of the film that you peel off.
Never tried the wet method, we use the hinge method which is to tape down one side, check your allignment, fold the resist back, remove the slip sheet and squeegee starting on the taped side. A plus doing it this way is that once the resist is squeegeed down, when you remove the taped hinge usually the carrier sheet comes with it.
Hope this didn't confuse you too much.
Dave
Born at night, just not last night. |