cannot blast thru rapid mask 3000 - Engraving Etc. Forum

<body> <h1>Full Version: <a href="https://www.engravingetc.org:443/archive/index.php?webtag=EE&msg=4607.19">cannot blast thru rapid mask 3000</a></h1><a name="a4607_19"></a><p><b>From: Engravin' Dave (DATAKES)</b> [<a href="lmessages.php?webtag=EE&msg=4607.19">#19</a>]<br /> 22 Aug 2006<br /><b>To: UCONN Dave &amp; Lynn too (DANDL48)</b> [<a href="lmessages.php?webtag=EE&msg=4607.17">#17</a>] 22 Aug 2006</p> <p>Dave,</p> <p>If you light fixtures with lenses you can get UV blocking film at any hardware store and cut it to cover the lens. It is usually with the other tinting films.</p> <p>After cutting to size, just open the light fixture set the film in place, then close the fixture. You are good to go.</p> <hr /><a name="a4607_20"></a><p><b>From: RALLYGUY (RALLYGUY1)</b> [<a href="lmessages.php?webtag=EE&msg=4607.20">#20</a>]<br /> 22 Aug 2006<br /><b>To: Engravin' Dave (DATAKES)</b> [<a href="lmessages.php?webtag=EE&msg=4607.19">#19</a>] 22 Aug 2006</p> That is also a good option.....We used to use exactly that, but the films do age and need to be replaced over time....when it was time to replace, we bought snap on covers for the bulbs. <hr /><a name="a4607_21"></a><p><b>From: UCONN Dave &amp; Lynn too (DANDL48)</b> [<a href="lmessages.php?webtag=EE&msg=4607.21">#21</a>]<br /> 22 Aug 2006<br /><b>To: RALLYGUY (RALLYGUY1)</b> [<a href="lmessages.php?webtag=EE&msg=4607.18">#18</a>] 22 Aug 2006</p> Brian and David,<br /> <br /> Thank you both!!<br /> Dave <hr /><p align="center">Show messages:  <a href="lmessages.php?webtag=EE&msg=4607.1">1-18</a>  19-21</p> <h4><a href="lthread_list.php?webtag=EE">Back to thread list</a> | <a href="llogout.php?webtag=EE">Login</a></h4> <h6>© 2025 <a href="http://www.beehiveforum.net/" target="_blank">Project Beehive Forum</a></h6> </body>