Dye Sub on Metal - Engraving Etc. Forum

<body> <h1>Full Version: <a href="https://www.engravingetc.org:443/archive/index.php?webtag=EE&msg=5096.25">Dye Sub on Metal</a></h1><a name="a5096_25"></a><p><b>From: Mike (MIKEN)</b> [<a href="lmessages.php?webtag=EE&msg=5096.25">#25</a>]<br /> 16 Oct 2006<br /><b>To: Harvey only (HARVEY-ONLY)</b> [<a href="lmessages.php?webtag=EE&msg=5096.24">#24</a>] 17 Oct 2006</p> I think you're right. I didn't try times longer than 60 seconds but there was consider ink left on the paper. Next time I'll extend it.<br /> <br /> For sure I'm going to Unisub metal though. <hr /><a name="a5096_26"></a><p><b>From: RALLYGUY (RALLYGUY1)</b> [<a href="lmessages.php?webtag=EE&msg=5096.26">#26</a>]<br /> 16 Oct 2006<br /><b>To: Mike (MIKEN)</b> [<a href="lmessages.php?webtag=EE&msg=5096.25">#25</a>] 16 Oct 2006</p> <p>Hi Mike,</p> <p>Unisub is properly done at 400 degrees for 60 seconds through the back. Aluminum conducts heat very efficiently, and it works just as well front or back with the temps and times.....Adding a pad can change the times however....so that will have to be accounted for.....</p> <hr /><a name="a5096_27"></a><p><b>From: Mike (MIKEN)</b> [<a href="lmessages.php?webtag=EE&msg=5096.27">#27</a>]<br /> 16 Oct 2006<br /><b>To: RALLYGUY (RALLYGUY1)</b> [<a href="lmessages.php?webtag=EE&msg=5096.26">#26</a>] 16 Oct 2006</p> Brian:<br /> Thanks, I'm getting closer. Just need to tweak it a bit. <hr /><p align="center">Show messages:  <a href="lmessages.php?webtag=EE&msg=5096.1">1-4</a>  <a href="lmessages.php?webtag=EE&msg=5096.5">5-24</a>  25-27</p> <h4><a href="lthread_list.php?webtag=EE">Back to thread list</a> | <a href="llogout.php?webtag=EE">Login</a></h4> <h6>© 2025 <a href="http://www.beehiveforum.net/" target="_blank">Project Beehive Forum</a></h6> </body>